The TUNZE Osmolator 3 is a simple and safe water level controller with optical control sensor and stand-alone thermal safety sensor for keeping a constant water level in freshwater and saltwater aquariums. A constant water level keeps the salt concentration in saltwater aquariums constant. If the water level drops, the Turbelle High Jet 5030 pump adds water up to the desired water line. An integrated safety sensor stops the pump in case of overfilling.
Simple and safe water level controller for freshwater and marine aquariums
Use of an optical control sensor and an independent thermal safety sensor
Maintaining the salt concentration by keeping the water level constant
Integrated dry-running and blockage protection
With magnetic holder, branded 12V DC power supply unit, hose and hose holder
Ideal for placement in under-cabinet filter systems or at the edge of the aquarium
The large, precise optical sensor...
detects the water level with an accuracy of 0.5 mm, resists air bubbles, deposits and scratches. The independent thermal safety sensor stops the Turbelle® High Jet 5030 pump in the event of overfilling, ensuring 100% overflow protection.
Plug & Play
All required components are ready for installation in the package (except reservoir). No software setup required. The fixed parameters are based on many years of experience.
Includes Turbelle® High Jet 5030
Long-lasting high-tech dosing pump Turbelle® High Jet 5030 with a maximum delivery height of 6.2 m (20.34') and pleasantly quiet operation thanks to a real 3-phase sine wave.
High-tech cable especially for demanding aquaristics
With remarkably high abrasion resistance, seawater resistance and extreme resistance to mechanical impact. As a result, it does not harden in water like PVC cables. With an extra high-contrast intermediate cable sheathing to detect damage at an early stage. Produced in Bavaria by MEDI Kabel.
Includes hose and hose connector
The set includes a corrosion-resistant, screw-in push-in fitting (¼ inch BSP to ø6 mm). In addition, a PU hose made entirely in Germany - low-emission, hydrolysis-resistant, microbe-resistant, flexible, but does not tend to kink when laid. The Turbelle® High Jet 5000.021 pump is therefore a practical 1:1 upgrade for Osmolator® 3155 and Osmolator® nano 3152.
Includes hose and hose connector
The set includes a corrosion-resistant, screw-in push-in fitting (¼ inch BSP to ø6 mm). In addition, a PU hose made entirely in Germany - low-emission, hydrolysis-resistant, microbe-resistant, flexible, but does not tend to kink when laid.
Compact all-in-one construction
With magnet holder and tube holder for an attachment to any aquarium edge or in the aquarium filter up to 15 mm (2/3").
Osmolator 3
Pump
Power supply:
3P von Sensor
Volume flow max:
160 L/h (Standard) 180 L/h (Boost)
Max. delivery height:
3,0 m (Standard) 6,2 m (Boost)
Sensor
Nominal input voltage:
12 V DC SELV
Power consumption measuring mode:
0,7 W
Power consumption Pump running:
5-8,5W
Ambient using temperature:
15-45°C
Using temperature water:
0-35°C
Detection accuracy:
0.5 mm The actual level fluctuation depends on the tank volume and pump power.
We use cookies on our website. Below you can choose whether and, if so, which non-essential cookies you would like to accept and you will receive further information about this.
